11 Meters Industrial Truck Spray Paint Booth Roller Door 11X5X5 M
1. 0.476mm color steel with EPS inside for wall panel.
2. Quality brand name turbo fan,with air capacity of 30000m ³/h
3. Pneumatic damper for spraying to baking cycle.
4. All panels are tongue and groove interlock structure
5. Control panel and other electric components can be purchased
6, Drive through door, roller type.
7, Side draft and down draft connected.
In painting, outside fresh air comes into the heating generators
through the pre-filter system, and enters into the plenum, then
filtered by ceiling filter and into the both which brings clean,
symmetrical and steady-going down airflow for spraying, After
painting, tot air goes from heating
generators to plenum, then enters room after filtered by ceiling
filter, providing heat that is necessary for baking of bus surface.
Afterwards, the air with little benzene will be released to the
atmosphere after being filtered twice by the exhaust air filter
|Inside dimension||11000×5000×5000 mm (L×W×H)|
|Outside dimension||11140×7940×5600 mm (L×W×H)|
|Front door (2sets)||Roller shutter door, 4000×4500 mm (W×H), One unit in the front, one
unit in the middle|
|Emergency door||2 units, 800×2000mm (W×H), colour: white.|
|Basement||Without basement, exhaust from two side walls and pits.|
|Wall panel||Thickness: 70mm, width: 1150mm, tongue and groove structure,
0.426mm colour steel with EPS|
insulation inside, colour: white.
|Light||Ceiling Lights: 18Units×4Pcs=72Pcs×36W, side light:
12Units×2Pcs=24Pcs×36W, without light tube, you put the LED light
at site, lighting box are powered coated.|
|Generator cabinet||Intake from side upper, exhaust from rear upper, quadrate steel
frame; white coated steel outside|
covered, galvanized steel inside, filled with heat preservation
material in the middle.
|Intake and Exhaust system (2 sets)||Inlet: 2 units, in total 2×11KW turbo fans, air capacity for each
fan: 30000m /h.|
|Outlet: 4 units, in total 4×5.5KW turbo fans, air capacity for each
fan: 18000m /h.|
|Heating system (2 sets)||2 units RIELLO G20 diesel burners, stainless steel heat exchanger,
pneumatic damper actuates|
from spraying to baking cycle. Max. heating productivity:
200000kcal/h, maximum temperature:
|Purification system||Pre-filter(pocket), ceiling filter, fibreglass filter, activated
carbon filter (pocket).|
|Control system||Spraying, heat spraying, baking, time setting, lighting switch,
failure indicator, thermostat, power|
supply switch, emergency stop, temperature limit controller, hours
meter. All motors are reduced-
voltage start, Romania language on the control panel.
48KW(powder supply:1×220V, 3×380V,50HZ)