Downdraft Car Spray Booth 6.9m Long Belt Drive Fan Diesel Burner
1, Blet drive fan for intake and extraction.
2. All panels are tongue and groove interlock structure.
3, #304 stainless steel heat exchanger.
4, All LED lights, energy save and more illumination.
5, Color white, blue, orange and red is optional.
6, OEM available.
In painting, outside fresh air comes into the heating generators
through the pre-filter system, and enters into the plenum, then
filtered by ceiling filter and into the both which brings clean,
symmetrical and steady-going down airflow for spraying, After
painting, inside the drying oven, hot air goes from heating
generators to plenum, then enters room after filtered by ceiling
filter, hot air circulation providing heat that is necessary for
baking of cars surface. .
Spray booth specification:
|Inside dimension||6900×3900×2650 mm(L×W×H)|
|Outside dimension||8450×4000×3400 mm(L×W×H)|
|Front door||Folding door, 3 folds, 3000×2600 mm(W×H), without frame, colour :
|Emergency door||1 unit, 650×1800mm (W×H), colour: blue, on the front door.|
|Basement||Galvanized steel assemble, 300mm high, quadrate steel support, full
grilles made by flat bar and twisted steel, then galvanized. 2
ramps, external setting, 750×3000mm/pc.|
|Wall Board||Thickness:50mm, width:1150mm, tongue and groove structure, 0.376mm
colour steel with 50mm thick polystyrene (EPS) insulation inside,
Ceiling Lights: 8Units×4Pcs=32Pcs×36W, with LED, lighting boxes
Side Lights: 8Units×4Pcs=32Pcs×36W, with LED, lighting boxes pen
|Generator cabinet||Intake from rear upper direction, exhaust from rear upper
direction, quadrates steel frame; white coated steel covered,
filled with heat preservation material in the middle.|
|Intake and Exhaust system||2×3KW double-intake centrifugal fans for intake, motor outside,
belt drive, model TAE-355, air capacity for each fan: 21000m3/h.|
|1×4KW double-intake centrifugal fan for exhaust, motor outside,
belt drive, model TAE-400, air capacity: 12500m3/h.|
|Heating system||RIELLO G20 diesel burner, stainless steel heat exchanger, electric
damper actuates from spraying to baking cycle. Max. heating
productivity: 20000kcal/h. Max temperature: 80 degree|
|Purification system||Pre-filter, ceiling filter, fibreglass filter, activated carbon
|Roof||Galvanized steel plates|
|Control system||Spraying, heat spraying, baking, time setting, lighting switch,
failure indicator, thermostat, power supply switch, emergency stop,
hour meter. Temperature limit controller, all motors are normal