Diesel Burner Heating Professional Spray Booth , Truck Paint Booth
1, Turbo fan for intake and extraction.
2. All panels are tongue and groove interlock structure.
3, #304 stainless steel heat exchanger.
4, All LED lights, energy save and more illumination.
5, Color white, blue, orange and red is optional.
6, OEM available.
In painting, outside fresh air comes into the heating generators
through the pre-filter system, and enters into the plenum, then
filtered by ceiling filter and into the both which brings clean,
symmetrical and steady-going down airflow for spraying, After
painting, hot air goes from heating generators to plenum, then
enters room after filtered by ceiling filter, hot air circulation
providing heat that is necessary for baking of cars surface. .
|Inside dimension||20700×5000×5000 mm (L×W×H)|
|Outside dimension||20840×9140×5600 mm (L×W×H)|
|Basement||Without basement, exhaust from both sides wall panel.|
|Front door||Folding door, 4-folds, 4000×4500mm(W×H), galvanized steel frame,
powdered and paint with blue color, with handle on both sides, EPS
inside, color: white.|
|Emergency door||4 units, 800×2000 mm (WXH), color: white, with air cut off system.
Safety Warning light display at each personnel door, with Emergency
Lighting at each personnel door|
|Room body||Profiled bar beams in the roof, to strengthen the room body; wall
panel thickness:70mm, width:1150mm, tongue and groove structure,
0.476mm color steel with polystyrene(EPS) insulation inside, color:
white. With Fire alarm Strobe light inside.|
|Light system||Ceiling Lights: 24Units×4Pcs=96Pcs×36W, side Lights:
28Units×4Pcs=112Pcs×36W, with LED, up and down interleaving
installation, access from outside.|
|Generator cabinet||Intake air from side upper direction, exhaust air from back upper
direction, quadrate steel frame, outside is white coated steel,
powdered and painted, filled with heat preservation material in the
middle, color: white|
Intake and exhaust
|Inlet: 4×7.5KW turbo fan, direct drive, air capacity: 25000m3/h/fan, with 5m intake stacks. (CE motor, but not Siemens brand)
(with electric damper)|
|Outlet: 4×7.5KW turbo fan, direct drive, air capacity: 25000m3/h/fan, with 5m exhaust stacks. (CE motor, but not Siemens brand)
(with electric damper)|
|Heating system||Riello G20 diesel burner, stainless heat exchanger, pneumatic
damper for spraying and baking cycle, heat productive 800000Kcal/h
totally, Max temp: 80℃, 5m stainless steel, chimney.|
|Purification system||Pre-filter, high efficiency filter (ceiling filter), fiberglass
filter, activated carbon filter (pocket)|
|Roof||50mm thick EPS heat preservation panels.|
|Control system||Spraying, heating spraying, baking, baking time, lighting switch,
failure indicator, thermostat , power supply switch, emergency
stop, time meter, ampere meter, voltmeter, temperature limiter,
pressure gauge, with inverters, delta start. (CE components, but
not Siemens brand)|
|Total power||68KW (1x240V, 3x415V, 50HZ)|
|Note||With one set electric lift inside the booth (one unit on each side)|