LED Lights Paint Prep Station Bay Schneider Components Turbo Fan
For Car Paint Sanding
Prepation bay special for the job before painting, under coat, base
coat, top coat, and sanding, polishing will be made in the station,
intake provide the fresh air, and exhaust extract the duct out.
1. Each unit with one 5.5kw fan for intake and exhaust.
2. Quality brand turbo fans, directly drive type.
3. Heating system option.
4. Rear side draft air flow.
5, Continue line with rail on floor option.
6, Led light and Scheider electric components.
7, Moveable infrared on the ceiling option.
8, Different job in different position at the same time.
9, PVC curtain between the stations.
Prep station used for making base coat, top coat, sanding and small
painting, outside fresh air comes into the booth through the
ceiling filter system, from the plenum, full down air flow comes
out, and extraction from rear side directly through fibreglass
filter and carbon filter, the air flow can be control by electric
damper. Mount on the concrete floor, easy for installation and
maintenance, the most importance things is the cost very low,
highly cost effective.
|Inside dimension||6300×3450×2650 mm (L×W×H)|
|Outside dimension||7550×3550×3100mm (L×W×H)|
|Plenum dimension||6300×3450×450 mm (L×W×H)|
|Room body||Back side EPS wall panel, the other sides PVC curtain.|
|Light||Ceiling Lights: 8Units×4Pcs=32Pcs×36W, with LED, lighting boxes are
|Generator cabinet||Exhaust from back side, galvanized steel frame; white machine-made
panel covered, filled with heat preservation material inside.|
|Intake and Exhaust system||1×5.5KW turbo fan, air capacity: 18000m3/h, with electric damper.|
|Purification system||Pre-filter, ceiling filter, fibreglass filter.|
|Control system||Fan switch, lighting switch, emergency stop.|
|Installs way||Hooked from roof by steel cable or supported by steel column.|
|Total power||6.7KW (Power supply 1×220V, 3×380V, 50HZ)|